-
Noticed a likely oversight today while I was out of my house - the touch screen will report a jam and pause the printer, but there's no output to fluidd (not even a console note) as to why the printer…
-
While the DIAG1 on X and Y axis can be used for sensorless homing, there I found additional usage of the stallGuard for E axis. It can be connected to filament sensor pin, to trigger the M600 when the…
-
When filament runs out, it is often quite curled due to being on the inner diameter of the spool.
When the IR sensor detects the runout, user is asked to unload the filament but when this is attempte…
-
Support three configurations:
1) Extruder on CAN-FD expansion, filament sensor on mainboard
2) Extruder on mainboard, filament sensor on CAN-FD expansion
3) Extruder on CAN-FD expansion, filament sens…
-
I don't know why, but sometimes the unload fails and I'm sure the synced unload not works if it fails.
It tries to unload to the buffer but the filament is still inside the extruder (toolhead sensor …
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
I installed two BTT SFS 2.0 on my IDEX printer, these are smart filament sensors with e…
-
Dear BTT,
how would you connect the SFS 2.0 to a SKR Pico?
best regards
-
Hello, I sometimes need to print without using the MMU, even without using the bypass, so directly from the extruder.
I tried to use MMU ENABLED=0 but I can't go forward printing, it just stuck after…
-
**Printer type** - Mini
**Optional upgrades** - Filament Runout Sensor
**Is your suggested improvement related to an existing problem? Please describe.**
I've just spent an hour trying to figure …
-
When printing from Python, the first print works fine, but the second triggers a filament runout on extruder 2 even though that extruder isn't used in the print. (As a workaround, and to confirm it's …