-
### Request for Implementation of "Support Enforcers" in PrusaSlicer CLI
Dear PrusaSlicer Team,
As a dedicated user and enthusiast of PrusaSlicer, I greatly appreciate the advanced capabilities …
-
# 🐞 bug report
### Affected Version(s)
Version 4.3
### Is this a regression?
The previous version (4.2) ran just fine. Now the UI is hanging.
### To Reproduce
Steps to reproduce the behavi…
-
### Version
2.1.1+win64-201912101512
### Operating system type + version
Microsoft Windows 10 Home 10.0.18363
### 3D printer brand / version + firmware version (if known)
Duet2 Wifi 2.05 (20…
-
Uart cable connector for RX & TX should be separate from 5V, 5V & GND.
Orange Pi Zero 2W has reserved GPIO pin 8 & 10 for UART0 for debugging & console.
If RX & TX cable were separate, then UAR…
-
Hey, I thought I'd let the LaserWeb team know that Quadratic and Cubic splines are now supported in dxf-parser 0.5.1. This could eventually lead to some kind of support for spline-to-gcode generation.…
-
### Version
1.40.1 beta
### Operating system type + version
Windows 10 build 17134
### Behavior
Slic3r turns on the fan at the layer time at which it should start slowing down, not the time s…
-
### Description of the bug
When slicing any model that has curving overhang perimeters(from what I noticed, may apply to others), the slicer outputs multiples of M106 enable fan commands before and…
-
# Feature Request
## Current behavior
Currently minimum layer time results in print speed decrease.
Not in all cases, this is good. For example, filament extruded in different speeds can have diffe…
-
**Is your feature request related to a problem? Please describe.**
I'm building a business using Bambu Printers, and I want to automatize the slicing process. However there are a few properties missi…
-
### Description of the bug
PrusaSlicer crashes on 2.7.3 when slicing.
PrusaSlicer
Version: 2.7.3+win64
Build: PrusaSlicer-2.7.3+win64-202403280959
Operating System: Windows
System A…