-
Hello sir
Thank you for your work sir, I have used your code sample sir.
I carried out impedance measurements with Rcal 10kohm and the results showed an accurate 10kohm, but when I took measurements…
-
Hi,
As [franka_interface/config/robot_config.yaml ](https://github.com/justagist/franka_ros_interface/blob/master/franka_interface/config/robot_config.yaml)says `# Internal controller for motion gene…
-
## Problem
Several users on the [OpenBCI forum](https://openbci.com/forum/index.php?p=/discussion/3726/electrode-impedance-test-using-the-gui-widget) report incorrect values from the electrode impe…
-
I mounted an ATU 1000 and I noticed that if you keep close you have 50 ohms everything works fine but with high impedance the tuning stops with high SWR around 3 or 6 .
Power and SWR readings are c…
-
The electrolyte might be wrong in:
https://www.echemdb.org/cv/entries/pajkossy_1996_impedance_209_f8a_dashed/
We should check all other entries in pajkossy_1996_impedance_209.
-
To reduce costs, the mezzanine board should be designed with a 2-layer stackup. A 50Ω impedance can be achieved with approximately 0.7mm-wide tracks and 0.15mm ground clearance, routed as coplanar wav…
-
The Rust and Motoko Result are isomorphic but don't match, leading to awkward interop with Rust canistes (i.e. all our system canisters).
What should we do about it?
1. Introduce a new Result li…
-
Hi
This is a very great projet and very good as i can see clearly the very basic of plugging a unit.. as using only 1 single lane. Very great work. If i may, i wonder.. was it 85ohms impedance match…
docop updated
1 month ago
-
Hi,
If you look carefully at the TI ADS1299 datasheet material, the 'Bias' electrode is the SAME as Ground in other EEG systems. This means that a SEPARATE ground connection to the subject is NOT r…
-
User using OE acquisition board with an Intan headstage can get impedance measurements but sometimes the impedance measurement fails.
When the impedance measurement fails, the loading bar of the Im…