-
Hello, I installed SpeedyBee F405 WING FC board with INAV 6.0 on my plane but the Altitude showed me incorrect position. 1300 meter instead of 0 meter (or close to that) Can you guys help me, please?…
-
## Current Behavior
Hi, I bought a ready-to-fly drone (Chimera7 Pro V2 6S HD) with a built-in GPS and magnetometer. I initially tried using INAV 7.1.2, but for some reason, it didn't recognize the ac…
-
Qvad X. Due to a different engine allocation, setting a new mix is unsuccessful.
Clean installation, chip reset, no cli reload.
And I can't change engine positions.
-
I flash the firmware I compiled into the flight controller, everything is fine, except that I cannot modify and save the mixer section. I tested three flight controllers, even if my firmware is not mo…
-
according the help page:
1. https://github.com/dotnet/runtime/blob/main/docs/workflow/building/coreclr/macos-instructions.md
2. https://github.com/dotnet/runtime/blob/main/docs/workflow/requireme…
-
### Describe the bug
Unable to update the stock firmware to BF 4.5.1
### To Reproduce
Enter DFU mode.
Choose board.
Load Firmware [Online]
### Expected behavior
Flash firmware.
### Support ID
…
-
## Current Behavior
When my quad was in acro mode, flying forwad at low speed, I activated RTH and the quad turned upside down in the air in its attempt to return home. After multiple swings It man…
-
### Describe the bug
Altitude sent by the FC to the transmitter over CRSF is off the scale or doesn't work at all. Before arming the absolute altitude is shown. Then just after arming it's resetted…
-
## Current Behavior
If you have switched on autolaunch the elevator is moving down.
Then you rais the throttle to idle speed and parallel the elevator is moving upwards (slow)
If you now throw t…
-
## Precommit CI Run information
Logs can be found in the associated Github Actions run: https://github.com/ewlu/gcc-precommit-ci/actions/runs/9898670422
## Patch information
Applied patches: 1 -> 1
As…