-
I'm not sure that the cli takes account of the settings for Print output and check synth args. These can both seriously inhibit SP performance (on a model B B+) . Would be good if there were an option…
rbnpi updated
7 years ago
-
I am testing the software but my device cannot be controlled.
I hit
TOLDO,io://2078-0794-8318/12516575,PergolaHorizontalAwning,Pergola,io:PergolaRailGuidedAwningIOComponent
TOLDO,io://2078-0794…
-
Tested with "MicroPython v1.23.0, cosmic_unicorn v1.23.0-1 on 2024-06-06; Raspberry Pi Pico W" - unfortunately I don't have any other appropriate boards to test with.
Steps:
1. Flash this https:…
-
is possible use `rpi_ws281x` and `adafruit-circuitpython-neopixel` to control ws2812b rgb led just like raspberry pi?
-
Latest CM3 runs (e.g. `cm3-run-16-09-2024`) have a net TOA energy flux around 2.7 W/m^2 initially.
Met Office GC5 AMIP runs were tuned to give the desired radiation balance at N216, not N96. The tu…
-
Im using QHY174GPS camera + HYCFW3 filter wheel connected to a Raspberry Pi 4B 8GB with AstroArch (with INDI and Kstars). Camera and filter wheel controla and adquisición seems to be working well howe…
-
We will be controlling the LED strips from a Raspberry Pi. We will need to control them from a program (written in Python, as much as I hate it).
[NeoPixels on Raspberry Pi](https://learn.adafruit.co…
-
Hello,
I'm currently working with the PickCube-v0 environment in ManiSkill2 (version 0.5.3) using the pd_ee_delta_pose control mode on Ubuntu 22.04.4 LTS. While the robot successfully reaches the d…
-
Any ideas to support raspberry pi gpio toggle a pin (switch a relay, for example)? This can be used instead of CEC, standby, etc.
-
I am using Python library to mock the PD device on Raspberry Pi in order to send the card information to the access control system and receive the commands (mainly LED and Buzzer). And I had troubles …