-
I am trying to train ChromBPNet on Arabidopsis ATAC-seq data, but run into the error `"Input file shifts inconsistent"` as in #153, #174 and #176. Having read through these other issues, I was able to…
-
## This issue is a
- [x] Bug Report
- [ ] Feature Request
## Hardware Configuration
- Raspberry Pi Revision (4B+/3B+/Zero/etc.): 4B
- Operating System: raspberry
- Matrix size: 128…
-
Hello,
I am having trouble controlling the enable pin for the spindle.
I am currently using the MKS SBASE platform and the CPU map is configured accordingly, the pins to control the enable for the…
-
# Version Number
Rev5b0
# Bugfix or Enhancement
This is an enhancement.
# Description
The MOSFET pins (MOS1-4) are currently driven by PE2-5. These are not all PWM capable because they lack t…
-
I have built one snsor whit a GPS M10 series, and I have connected it to a FRSKY receiver and Tx X20S. The data of Lat, Lon, Alt, Speed work correctly but the route always marks zero. Does anyone ha…
-
Hello,
Is there a command I can send to the lidar to make it stop scanning, and still accept serial commands, and then start scanning again?
Can there be a hardware solution?
Best Regards,
…
-
I use GRBL 1.1 with laser cutter.
I do not understand $30, $31 and $32
$31 and $32 is almost understandable, but $30 is not clear.
Why my laser is working with 100% all time when $32?
how exactly …
-
Hello. Can I connect a laser module to the board for engraving? It is necessary to enable and disable it with commands g-code without PWM. I want to do both like in the RAMPS + ARDUINOMEGA board with …
-
Issue https://github.com/roboticslab-uc3m/yarp-devices/issues/234 led to a short discussion on future plans regarding firmwares and their wrapping YARP devices. Short summary at https://github.com/rob…
-
Hello,
I am using a ST7755S based 1.7" display (160x128). When i go to setup the SPI bus in circuitpython and then initialize this ST7735R driver, the screen usually displays garbage, then wipes c…