-
_The following is drafted by @DanLi-BU with light edits by @sunt05_
---
OK, now at least I think I can elaborate my questions clearly. Here they are:
1. in `wrfinput_d04` ([attached](https://…
-
> * Simulations with more than 7 layers (I have looked at 9 but will likely be the case for others) do not run to completion, despite the capacity of SUEWS-SS for up to 15 layers.
Have you tested a…
-
`res_mod_state` will be extended to include more info for debugging.
https://github.com/UMEP-dev/SUEWS/blob/147e59f4285c3df7c65fbdd4feb5f8fcb4f152e7/src/supy/supy/_run.py#L146-L147
-
https://github.com/UMEP-dev/SUEWS/blob/1d4c7677c49c6f4d1bed0c2701ed13dec9b1756c/src/suews/src/suews_ctrl_driver.f95#L2319-L2335
- [x] #231
- [x] #128
-
discussed with @ljarvi: this should be fixed.
https://github.com/UMEP-dev/SUEWS/blob/37da3415d54fbdec9098727a6e6b0d9a91f7d0c2/SUEWS-SourceCode/src/suews_phys_snow.f95#L718
-
In a few situations, using supy version 2023.7.3.dev0 with the multi-layer SS doesn't work. In these cases, when run with another branch (), SUEWS did run before. This has been tested by swapping out …
-
When printing our surface resistance in the SUEWS output file, the model prints out ****** as the resistance values get too large. In the calculation of RS some limit for not getting too high values s…
-
There is a severe issue in the model code when SnowUse is set to 1. Before major changes in the code structure after V2020a, snow was calculated in such a way that it was using snow specific equations…
-
There is an issue with surface temperatures when using both SS and NARP, when using the new ESTMExt. After examining both the surface temperatures output, and the fluxes, I think this is due to a temp…
-
Running SUEWSSimple multiple times creates error since a file cannot be created cos it already exists. @sunt05 , if I was to run outside of QGIS/UMEP, would it be possible to re-run same data with sam…