-
### Description
Not sure if this is an issue with the SPI or the TMC library so close if its out of place. I am having issues with all the TMC2660 drivers in marlin.
M122 Below -------
```
…
-
First off please assume I know nothing about coding, marlin, or anything.
I'm just trying to change the max temp on my SKR Mini E3 using VS Code and Platform IO
All I changed was #define HEATER…
-
I'm using the RDGLCD and from time to time I accidentally bump into the encoder after having exited the menu, thus changing the speed multiplier by a small percentage. It could be useful to add a "del…
-
I have a Cypress CY8CKIT-062-BLE kit. When I run the command `mbed detect` I get this message
`[mbed] Detected None, port COM31, mounted D:, interface version 0254:
[mbed] Supported toolchains for…
-
#### What were you doing?
1. In the panel menu go to Probe > Z Probe
2. Before the probing finishes, go back to the Watch screen.
#### What did you expect to happen?
Z probing to finish succes…
-
#### What were you doing?
G28.2 Z to home only Z Axis
#### What did you expect to happen?
Z Axis to home the same as with G28.2 as follows:
Move at fast home speed to Z limit switch
…
-
When I try to use Universal GCode Sender with my new Shapeoko running Smoothieware I get this;
***\* Connected to COM10 @ 9600 baud ****
Smoothie
[verbose][Error] Error while processing response : At…
Leary updated
4 years ago
-
`
Processing BIGTREE_SKR_PRO (platform: ststm32; board: STM32F407ZGT6; framework: arduino)
Verbose mode can be enabled via `-v, --verbose` option
CONFIGURATION: https://docs.platformio.org/page/b…
-
I cannot get the GTR firmware to compile using ATOM, or VSCODE, the guide that the documentation refers to is for another board entirely, I spent 70 bucks getting this thing to me and I'm very offset …
-
Is anybody else seeing layer shifts on BugFix 2.0.0 ? I'm seeing one or two of them on long prints. I'm seeing them on the X-Axis (and mostly in the negative X direction).
I'm running an IDEX m…