-
Hello, I would like to run TMC5160 with this methods that come from the other library
`TMC2130Stepper `
These three methods are the ones I have in doubt
```
//driver.interpolate(1); // But genera…
-
Recently the TMCStepper library has been upgraded to support ESP32 better and handle daisy chaining.
I was previously using my fork of TMCStepper for some testing of these features. Now that every…
-
Homing normally works just in first time. In second time homing don't work normally.
For example:
G28 X0 - homing normally to 0 postition, then repeating G28 X0 comand X axis moving to + position.
…
-
I just got my new SKR Pro 1.1 and now tried to flash the marlin firmware.
I cloned the BIGTREETECH-SKR-PRO-V1.1 marlin firmware and made some adjustments in Configuration.h, Configuration_adv.h and…
-
### Bug Description
Sometimes my BLTouch won't deploy the push PIN on the Z Home command. It just stays up and the hotend crashes into the Heatbed. When i manually run a self test (M280 P0 S120) I …
-
Hi,
So I'm currently trying to replace my Creality CR10 S5's motherboard with a SKR 1.4 Turbo. I purchased this along with TMC 2208 v3 Drivers. So far I've got most things working, from the motors …
-
Just installed the board on my Ender 3 and uploaded the new firmware and now I get this error everytime I try to turn on the printer Driver Error: 8 Printer Halted I am using TMC5160
-
Hi
I have an SKR 1.4 Turbo. I've installed TMC2208 driver (UART mode) in X, Y, Z axis (this works) and i have tested A4988 (motor is stuttlering and dont change direction), DRV8825 driver (motor do…
-
hi,
thanks for the amazing lib!
i'm experienced using TMC2100 drivers, and i've recently bought a TMC2130 to try running it through SPI and thus have the amazing load sensing capacity of these d…
-
Hi.
Just purchased the above card with TFT35 and TMC2208 drivers.
Screen says printer not connected. Downloaded new firmware for screen with new icons, which has updated ok, but it is not talking …
SevCr updated
4 years ago