-
### Description
### Steps to reproduce
1. [First Step]
2. [Second Step]
3. [and so on...]
**Expected behavior**
**Actual behavior**
### Additional Information
* Include a Z…
-
I have the PAD 5 - I finally managed to get a CM4 ( 2GB lite version) I managed to get RaspiOS ( Raspian) installed. Even after following the instructions in the manual - including the overlay stuff I…
-
As titled. Please add what this jumper does to the manual.
-
Replaced a V2 version with V3. All the fans are running and the house is nice and cool, so unless there is a new cooling requirement it should work. But what I get is after approx 30 min the print j…
-
Hi all,
Just bought a new BTT SB2209 with an RP2040 and wanted to install Katapult to be able to flash it over CAN. I ran through the instructions until it was time to flash to the board, and I was…
-
I can compile BIGTREEE_OCTOPUS_V1 but not the ...USB version. I believe the first error is:
C:\Users\holol\.platformio\packages\framework-arduinoststm32@src-37335c727965154be67d1d5ed653b9c6\cores\a…
-
-
Can not get any response from your Programme (Marlin3DprinterTool). I am using Windows 10 connected to a Bigtreetech GTR V1.0 board with Marlin 2.0.9.1 installed. When I select the correct board rate…
-
Starting this thread as I work through getting an up-to-date bugfix Marlin implementation running on my not-very-Ender 3v2.
After getting the probe successfully operational on my Creality 4.2.2 boa…
-
I have enabled EEPROM in configuration.h
Using the LCD I can save setting to the EEPROM but when I power cycle the printer the settings don't return unless I manually load setting from the LCD pane…