-
Hello developers,
I use the 3D printer "anycubic-predator":
https://www.anycubic.com/products/anycubic-predator-fdm-printer
The filament here is PETG. That doesn't warping. But after a while th…
-
I have a delta printer that has tiny deviations in X-Axis and Y-Axis sizes.
I have tried to find the reason and calibrate. But it is not easy to do this on a delta printer.
While you could solve thi…
-
### Version
2.3.55.2
### Operating system type + version
Win10 x64
### 3D printer brand / version + firmware version (if known)
Different
### Behavior
"Extruder Clearence" setting is depe…
-
Just like in 1.6, any time I attempt to slice a model using a configuration that's perfectly valid in MatterSlice, it instantly fails with a slicing error if I try using Slic3r. The last time I brough…
-
### Issue description
When running G29 the printer is homing and after that going into position as set in configuration_delta.h in Z_PROBE_DEPLOY_HEIGHT and then stops. No further move is made, even …
-
A while back, I wrecked my delta because it has no min endstops or other software checks to avoid crashing the carriage into the floor. Two motors later...
I have once again wrecked my delta printer,…
-
I would like to probe more points when performing BED_MESH_CALIBRATE.
Currently this is limited to 5 points with a delta printer.
Can this number be increased somehow?
Thanks, Mat
-
As soon as the Hotend fan is running I get permanent "Some problem encountered, Z-Leveling enforced". This happens when 3 or 5 calibration attempts are selected in the calibration menu. I am quite sur…
-
I have installed the plugin, however Cura (4.12.1) doesn't recognize Monoprice Delta Mini V2.
Error message is "Could not connect to device."
The printer is online and connected to Wifi, Wiibuilder …
-
i have the following nasm which loads a part of itself into a region in memory and executes from there .
replaying it backwards with rr crashes when it enters the mmaped region.
nasm code `test…