-
**Describe the bug**
I have a car with an 8chan wired up. If I control the main relay pin (meaning the main relay pin is assigned to Main Relay output), i connect usb, and I key on, the ECU hangs. If…
-
`scan-reset` uses `wait_for_ecu()` to await the ECU coming online again. The case when the ECU dies is not handled. Allow `wait_for_ecu()` to raise a TimeoutException.
-
Since we do not have resources available to have LTS we need a way to read FW (and tune?) From ECU
-
# Steps to reproduce
Connect to an ECU which communicates using KWP2000 over K-line and perform a `ReadIdent`. ECUs I have tried (all of them in a 2005 Audi A4, type 8E/B7):
* `0x37`, Radio/navi…
-
First of all, thank you so much for your effort in creating this program.
My setup is a 2014 Subaru Outback with the VAG COM 409.1 KKL Cable. The cable uses the FTDI FT232RL chip with a virtual CO…
-
Can we do anything to diagnose injectors without taking engine apart?
-
@abricosvw says his Ford Mondeo can crank engine without injection and ignition and verify relative compression between cylinders
That looks SO SEXY!
-
### Describe the bug
I have successfully installed the comma 3X with Hyundai Q harness on my Ioniq 5 2022 (no HDA 1 or 2 or 1.5) in Taiwan, Asia. After installed the stock openpilot (release3), it st…
-
I am connecting dltviewer (tried with v2.26.0, v2.27.0, v2.18.0) with dltdaemon (https://github.com/COVESA/dlt-daemon/tree/master) over UDP. I am able to receive log messages from dltdaemon over both …
-
# Background
UDS(Unified Diagnostic Services) is an automotive protocol that enables the tester to communicate with the ECUs in the vehicle to diagnose faults, change configure, or even reprogram the…