-
## Precommit CI Run information
Logs can be found in the associated Github Actions run: https://github.com/ewlu/gcc-precommit-ci/actions/runs/9873692777
## Patch information
Applied patches: 1 -> 1
As…
-
Board: WING FC/FF35 version 0
Configurator: INAV 7.0.1
INAV 7.0.0 and the later versions 6
Trying to set up as a simple 'Wing FC' for a small 'Z84 Wing' i.e. 1 motor, 2 servo's, GPS, No FPV.
I…
-
### Describe the bug
Hello,
I have a JHEF405 GF16 FC and a betafpv M03 VTX, and I can't seems to make smartaudio working between the two. This is somewhat problematic as this vtx don't have other me…
-
### Describe the bug
When you turn on GPS, the craft name parameter is overwritten. Moreover, all this is stored in EEPROM.
I don’t know, maybe it occurred to someone to do this on purpose, but i…
-
SpeedyBee f405 wing mini
Inav Version 7.1.2
Ranger T1
Hello everyone,
I built a Ranger T1. Everything went well, but the engines don't run after arming, despite 3D fix and pre-arm check every…
-
## Current Behavior
## Steps to Reproduce
1.Soldered white SA wire from Cricket to ST1 pad of F411
2.Enabled Soft Serial in Config tab of iNAV
3.Enabled TBS Smart Audio on Soft Serial in Por…
-
### Describe the bug
While dropping Throttle to Zero my quadcopter continues to ascend. Blackbox logs show that Motors 3 and 2 are start at 45% while 4 and 1 are at 0% while Airmode attempts to hold…
-
## Current Behavior
The 7" Quad is flashed with regular INAV 6 and since then has changed dramatically in behaviour after disarming as after landing properly. I looks like the quad doesnt figure that…
-
### Describe the bug
I have the gps rescue sanity checks set to “on failsafe” meaning it should let me gps rescue even when right next to the home point. But when I activate gps rescue, the quad just…
-
## Current Behavior
It is not possible to arm the drone. GPS is mounted and for PID tuning I would like to use system without GPS fix to speed up process. Therefore I disabled all relevant GPS settin…