-
I have a problem with the latest release of the MySensors library.
I have a RPI3 as a gateway and several sensors with RMF69 radios. With the old version (2.2.0) everything worked fine.
Now I've s…
-
``` c++
CLEAN SUCCESSFUL (total time: 15ms)
make -f nbproject/Makefile-default.mk SUBPROJECTS= .build-conf
make[1]: Entering directory 'C:/Users/Peter/MPLABXProjects/practice_master_clone_a.X'
m…
-
EUI64 device is not present on I2C bus
Should be at address 0x50 (7bit)
Scanning...
I2C device found at address 0x3C ! OLED
I2C device found at address 0x44 ! SHT31
I2C device found at addr…
-
I am just getting started with the sketch, but it looks like I should just be able to upload it to the ESP and configure once it's started. I am able to load the sketch, compile, and upload to both N…
-
Idea partly inspired from here: https://github.com/whaleygeek/pyenergenie/issues/77
And mentioned here:
https://twitter.com/jmigreen/status/1123699248569229315
@jmigreen
Idea would be per…
-
Hi Alexey ,
Have you heard of mysensors project? https://www.mysensors.org/download/sensor_api_20.
I have a small mysensors network with rfm69 radios. It works great and the challenge is to buil…
-
I was looking for XBee + MQTT and here I am :)
I'm currently using no protocol at all for my XBee sensors and I'm starting to think that maybe I should.
ZCL does that but is really complex.
I've deve…
-
@dekay
I have an ISS with markings Revision E3, and a Vantage Pro 2.
I built out a 3.3V atmega328P with a RFM69HCW wired appropriately.
have you tested with any of the latest firmware versions o…
-
Pagina home
- [x] Display Zone
- [x] Display Scenari
- [ ] Display Grafici [tempo di accensione,consumo,temperatura,umidità,luminosità,pressione] dei nodi
- [ ] Display Nodi [stato(onl…
-
Would it be possible to provide some example/demo code?
E.g. a small 'echo' program that listens for incoming data and replies the same data to the sender?
bc547 updated
3 years ago