-
If using Slot 2 and Slot 6, there is a wrong Delay on the SBUS2 Signal.
Slot 6 is on the Timing of Slot 5
You shouldn't skip Slots
-
This is probably not an issue with the library but I'm using an Uno with an SN74HC IC and it's not sending any telemetry data. Maybe there is a way to conversate about a solution.
-
i was wondering if there are any plans to implement Futaba S.Bus2 support so that Futaba receivers can have telemetry sent back from the Flight Controller?
-
Hi everyone,
I have configurate my new quad, I have alredy flight, but i can't use AUX channel exept 4 for set modes
When I use with the R7008SB sbus2 I can set up 4 aux ch more but not 1to4.
Is no…
-
@pkocmoud @nickarsov @kd0aij This is to discuss schematic revision 13.
[PIXRACER-R13.pdf](https://github.com/PX4/Hardware/files/93463/PIXRACER-R13.pdf)
[Pixracer_RC13_CEO_report.pdf](https://github.…
-
Hi there,
I understand that according to [this mbed post](https://developer.mbed.org/users/Digixx/notebook/futaba-s-bus-controlled-by-mbed/), the stop byte at the end of every packet is supposed to…
-
Expanding on the DSM2/DSMX serial protocol that is already available but limited to 6 channels, I'd like to see some serial protocols available on the PPM output pin in the module bay. Specifically SU…
-
In the file src/modules/px4iofirmware/mixer.cpp around line 286:
``` c
if (mixer_servos_armed && should_arm) {
/* update the servo outputs. */
for (unsigned i = 0; i < PX4IO_SERVO…
-
Target Naze32
I am not able to get SBUS working with a Futaba R3008SB. I tried it in all possible combinations:
- with and without inverter cable
- using input 4 (the one under GND) and not working o…
-
I just replaced my FASST PPM sum receiver with an SBUS Type (Futaba R6108SB). After that, the throttle failsafe recognition is completey messed up - fly-away is guaranteed on RX problems.
My setup:
T…