-
Not only that it defaults to the hardware modified version, most people like me took time to figure this out. 2nd where are the hardware things I need to do to use the improved option?
-
Hi , I am integrating Si5351Arduino on an ESP32 micro using arduino IDE.
I get erratic behaveures when using the set_freq and set_freq_manual methods; in particular:
1) the status is always as follo…
-
I have used the exact same board on three arcade boards. I am using an ESP8266 with an Si5351 on board. The board works great on one arcade board and my Amigas but two arcade boards are not.
One is o…
-
Hello,
I have ordered NanoVNA and waiting for arrival of stuff.
Looking at schematic, I felt that SA612A OSC input signal is a little bit large.
Refer to SA612A data sheet, OSC input signal (…
-
Probably, the example m_si5351_regs_15to92_149to170 array should be cut? Moving it into an example would make much more sense. Moreover, the exact format of this array is not an exact output from the …
sx107 updated
3 years ago
-
Can You add phase shift configuration for outputs ?
-
![image](https://github.com/enjoy-digital/litex_m2sdr/assets/1450143/8d054d9e-63d5-4c0f-9ef3-a093ca7a0aa4)
- [x] Integrate SI5351 core.
- [x] Test on hardware with 148.5MHz and 148.35MHz confi…
-
Arduino: 1.8.20 Hourly Build 2022/04/25 09:33 (Windows 10), Board: "Raspberry Pi Pico"
Wire
"C:\\Users\\sreer\\AppData\\Local\\Arduino15\\packages\\arduino\\tools\\arm-none-eabi-gcc\\7-2017q4/bin…
-
Add build support for the MS HW variant as proposed in [this discussion](https://groups.io/g/nanovna-users/message/30942).
-
void freq(int32_t fout, uint16_t i, uint16_t q){ // Set a CLK0,1,2 to fout Hz with phase i, q (on PLLA)
uint8_t rdiv = 0; // CLK pin sees fout/(2^rdiv)
if(fout > 300000000){ i/=3; q/=3…