-
### STOP! ATS 20+ users!
The below isn't needed!
**G8PTN** has pointed out that it HAS the needed resistors already on the A1 pin of the device...
Please follow his advice, and leave your solderi…
-
In this task we research about differents types of soldering paste that can be use on our project. We looked the melting point and the soldering graphic.
-
After buying/soldering/cutting came to flash firmware and end up with message: not a valid firmware! Downgraded Edge from 21.0.4 to 21.0.0 and switch to oledpocket2100.bin - same message. Feel like...…
-
do you have schmetaics for this project. and how to enable soldering iron parts too in this code.
-
Soldering:
- 2x rows of 15pin female header (for the ethernet module)
- 2x rows of 4pin female header (for RF module)
- ceramic capacitor (for RF module)
- 7x color cables between ETH module and RF mo…
-
**Is your feature request related to a problem? Please describe.**
When using my Pinecil V2 for embedding brass inserts into 3D prints, maintaining the soldering iron perfectly perpendicular to the i…
-
Hi! I'm fascinated by this project. I've been following it for a while, and now the motor is back in stock I'd love to build one of these myself.
However, I only have some basic soldering stuff, a…
-
Every time I have used the soldering iron I have had to fight with it to get the finished circuit board removed. Sometimes it will show the finished circuit board in the correct place, sometimes it wi…
-
Hi ALL
i‘ve successfully flashed Tasmota and done the GPIOs soldering.
when i now klick on „Firmware Upgrade“ to Upload the portisch.hex i get a error Message „File Upload failure code 210“
Do yo…
-
Has anyone built the keyboard using reversible PCB?
Would be great if you can share some helpful tips.
To keep the pricing low and nobody to share the cost of PCB printing, I decided to go this ro…