-
Hello everyone,
atm I´am working on a big selfmade Delta-printer for Ceramics.
The setup:
- Skr Pro
- TMC 5160 V1.2 BTT (removed the CLK Pin)
- Nema 23, 3 A, 1,8°
- 24 Volt Power supply
- RepRa…
-
Hello mates,
I have been looking for a solution to this problem for two months.
When I try to print from USB or from BTT TFT24, the printer stops randomly. Motors on, heaters too: bad situation.…
-
So I've been running my CNC with CNCjs on my MacBook for over a year without any issues. I have version 1.9.26 installed via the Desktop App. I now want to switch over to running the machine with a Mi…
-
Hi,
Really like this project.
Do you think it would be feasible to support a wider range of voltages, up to 48V or 60V for use with large machines and motors?
-
I'm attempting to use BigTreeTech's TMC5160 breakout board via SPI for controlling a 2.0A NEMA bi-polar stepper, in the interest of integrating the Trinamic StallGuard capability into my project. The …
-
Good day !
I ask for help in solving the problem !!!
My kit : SCR Pro v1. 1 & TMC5160 x 6 & Motor 24V 1.8 deg 2.0 A x 5 & Motor 24V 1.8 deg 1.5 A & Motor 24V 1.8 deg 3.0 A & Marlin 2.0 !
My task…
-
With the current design, some motors behaving erratically can seriously damage the arm or cause injury to anyone nearby. The motors we're using are powerful; if the code does not regulate them properl…
-
I'm an electrical engineer (not software super person) using a TMC5160 with an encoder. I found that no matter how I set ENC_CONST using this library's function, it would only ever set the lower 16 bi…
-
Hello. TMC2208 drivers are controlled by the UART interface.
Is it possible to add support for TMC2208 drivers in firmware (1.04)?
-
Got sensorless homing working fine with FYSETC TMC2240 and the following config:
[tmc2240 stepper_x]
spi_software_mosi_pin: PB15
spi_software_miso_pin: PB14
spi_software_sclk_pin: PB13
cs_pin: P…