-
Hi all, I use Tasmota based and other devices for my home automation for many years already.
I already also use the reduced version of esplink for transparent serial communication via wifi with other…
-
Hi Koko,
This is about Flipper Zero WiFi Dev Board.
1. I flashed the firmware with flasher script using [this tutorial](https://github.com/justcallmekoko/ESP32Marauder/wiki/flipper-zero). The fl…
-
It is possible to lock the device to communicate only with a particular host.
The implemenetation would look like this:
- trezor bridge would collect various serial numbers (such as MAC addresses …
-
This request comes a little ahead of its time since this ITead Sonoff ZBBridge-P is not available to buy yet, but it will be soon ;)
https://community.home-assistant.io/t/itead-sonoff-zbbridge-p-co…
-
I have a WiFi network but I cannot seem to connect when trying to connect on the https://hq.pinocc.io/troops main page, what is wrong?
-
# Use your TouchScreen with Klipper on Sidewinder X2 | freakyDude's Blog
Intro If you have been following my recent posts, you know that I switched from Marlin to Klipper firmware on my Artillery Sid…
-
First off, awesome work, I was delighted to find this repository while I was waiting for my bed to arrive, I've got a bedtech that uses a HJC9 w/ BLE, and I'm also looking to add my bed into home assi…
-
Hey folks.
I'm a developer of a few audio boards that work with snapclient, including [Louder-esp32](https://www.tindie.com/products/sonocotta/louder-esp32/) and [Esparagus](https://www.crowdsupply…
-
I am trying to have a mesh network which one of them is Gateway and it need to be connect to WIFI and internet to transfer data by MQTT. I am using PainlessMesh to create the mesh.
Issue I have When …
-
I am using the tuanpmt code & libraries to run an Arduino multi sensor to send mqtt messages through a ESP8266 (Bridge Mode)
The code below runs ok, but the trouble is that it only publishes the mess…