-
I have a very specific question related to Eachine X220S.
1. I am using Taranis Plus as a TX.
2. Using Taranis X8R Rx.
3. Beta Flight 3.2.1
4. Flight Controller F3 6DOF
The receiver is correctl…
-
I am use blackbox explorer v2.5.10.
FC, brf3
battery, 4s
quad, 4 motors
after flash firmware 3.1.6 and restore settings, I found current_meter_scale is missing, so I add current scale in GUI dir…
-
I use the safer arm switch logic on my taranis qx7 and it works great.
However, I use a devo7e transmitter for my micros and there is no logic programming available on the tx.
I have tried searc…
ghost updated
7 years ago
-
Generic i2c_nav board has pins for connecting a sonar. There should be a possibility to read from it.
-
http://fpvlab.com/forums/showthread.php?34250-MWOSD-for-BETAFLIGHT-CLEANFLIGHT-RACEFLIGHT-PIXHAWK-KISS-DRONIN-INAV-and-others&p=829684&viewfull=1#post829684
would be great if added to master branch
-
So, I'm thinking it might be nice to get rid of the weird baseflight/cleanflight motor mapping and replace it with the following (before our user base gets too big):
- The front right motor is num…
-
The Sparky hex corrupts the board prompting an unrecognised target message in windows devices, the bootloader bins must be shorted to allow re-flashing of cleanflight.
(It's a shame as I was looking …
-
cleanflight 2.0.5, PIKOBLX board, configurator 2.0.3
when trying to set ibata_scale to a negative value it is not accepted but allowed range is positive and negative
`# set ibata_scale = 1000
…
-
I flashed cleanflight 2.1 rc1 on my dys f4 aio using the omnibusf4 target. It works for the most part except that the osd shows the betaflight logo when booted and other random bits of information th…
ghost updated
7 years ago
-
Hello! I'm new to betaflight/cleanflight. I followed this tutorial: SITL in gazebo 8 with ArduCopterPlugin and it gave me an error:
make: arm-none-eabi-gcc: Command not found
make/tools.mk:294: *** …