-
## Current Behavior
When my quad was in acro mode, flying forwad at low speed, I activated RTH and the quad turned upside down in the air in its attempt to return home. After multiple swings It man…
-
## Current Behavior
I only got 14 channels.
## Steps to Reproduce
Hyppymodel 2.4 EP Dual
flash from 3.2.1 to 3.3.0 channels dont work
flashed back to 3.2.1 channels work again
## Possible S…
-
### Play Version
2.9.0-RC3, 3.0.0
### API
Scala
### Operating System
```
Linux 5.15.0-88-generic #98~20.04.1-Ubuntu SMP Mon Oct 9 16:43:45 UTC 2023 x86_64 x86_64 x86_64 GNU/…
-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### What part of EdgeTX is the focus of this bug?
Other (Please specify below)
### Current Behavior
Upda…
-
INAV CONFIGURATOR 7.1.1
FC FIRMWARE7.1.1 [SPEEDYBEEF405V3]
When I flash iNav onto my SPEEDYBEEF405V3 FC the motor tab doesn't show any of my motors. The only thing I see is a master slider.
…
-
### Describe the bug
i have following problem.
My drone does take a long time to start up the ESC.
Sometimes it takes longer than 20s and sometimes much more longer.
But when the FC is plugg…
-
inav wont read my accelerometer or gyro only barometer...everything works in betaflight..no issues
-
## Overview
After my disastrous first attempt at doing telemetry, I have decided to split adding full telemetry support up into smaller & easier to manage modules, based on the types of telemetry b…
-
Does ExpressLRS Support Displaying Altitude From Barometer Sensors?
In my case,when there is no GPS signal,the relative height is always "0",but the vertical speed can be displayed.
ExpressLRS versi…
-
i flash the test for acessing the pwm . i nuke the rp2040 to be shure to start new. all seam to work serial connection act as usual , set all the parameter as usual and all is set when a look in the s…