-
Hi all, I am new with the Sonoff devices. I have a Sonoff Basic and I' ve flashed in it the Tasmota firmware following these configurations:
/*
user_config.h - user specific configuration for So…
-
Theo, if I compile the last distribution there are some errors about new declaration and old declaration.
xsns_bh1750:44: error: new declaration 'boolean Bh1750Detect()'
boolean Bh1750Detect()
…
-
Perhaps it's useful, so here are the latest results from "cargo run":
pi@gateway:~ $ cd MySController-rs/
pi@gateway:~/MySController-rs $ git pull
remote: Enumerating objects: 83, done.
remote: …
-
If I flash a Wemos D1 with Arduino 1.8.5 over the COM port with the current mega version, it does not start.
Testet with 2 Wemos Boards.
I get:
ets Jan 8 2013,rst cause:4, boot mode:(1,6)
…
-
-
In the file "ZsensorBH1750.ino", the Wire.requestFrom() is encapsulated by Wire.beginTransmission() and Wire.endTransmission(). Those can be removed, since the Wire.beginTransmission() and Wire.endTra…
-
A few comments in one:
1. There are GPIOs 1,3,4,5,12,13,14 available on Sonoff DEV board.
In configuration UI are 1,3,4,5,12,14 only. Did I missed something, or it is the correct state?
2. On Son…
-
The Wire.beginTransmission() and Wire.endTransmission() are only used when writing data.
In the files:
"NodeMCU/NodeMCU-WIFIClient--GY30/NodeMCU-WIFIClient--GY30.ino"
"NodeMCU/NodeMCU-WIFI-HTTPSe…
-
Hello everyone,
I am using Sonoff POW to monitor Power Consumption Data. I have used the latest version (5.13.1) of Sonoff-Tasmota. I am not able to get the correct time in the data that Sonoff POW…
-
I couldn't find any examples in the code even though they are listed in the README . Did I overlook them or are they still a WIP?