-
Hello, complete noob, needs advise on his setup.
single motor, 57BYGH420-2 ( nema23, 2a per coil,
https://french.alibaba.com/product-detail/stepper-motor-57bygh420-2-125-oz-in-200-steps-rev-600mm…
-
Ramps1.4/Mega2560
24V mod
POWER_SUPPLY 1 (M80,M81)
Marlin1.1.8
Octoprint
TMC2130 X,Y
DRV8825 Z,E
Sorry for lengthy story but I'm pulling my hair out and I've googlized a bunch. Thanks for yo…
-
Hi laurb9,
First, great job on making this library!
I may have spotted a tiny error I thought I'd bring to your attention regarding the DRV8825.
In the 'Microstepping' example code you comme…
-
I have a DRV8825 stepper driver. I've used it with Arduino UNO. Can webusb control drv8825?
-
as per subject would it make sense to update Ramps FD ? are there any improvements that could be made?
-
Is it possible to change the z-axis increment when doing probe / autolevel?
I am aware that I can change the RATE of jog with the "Probe Feed". But this is rate (distance per unit time). I hope to …
-
Hi, I was using your code and I tried to run `python stepwavetest.py` when it gave me the error
> File "stepwavetest.py", line 246
yield self.steppinmask, 0, 0
SyntaxError: 'return' …
-
In order to reduce confusion, we should let the machine derive the values rather than calculate them externally.
The worksheet will still be used for planning, and doing 'what if' scenarios on vari…
-
Hi Luni64, I am currently trying to implement your TeesnyStep Library on a Teensy 3.2 with 2 X Steppers driven by DRV8825 boards. I am trying to run the simple example & keep getting lots of errors. I…
-
RPM value is correct at full step mode, but the number of degrees asked and the speed are multiplied by the microsteps value, hence directly going against the commented affirmation
" * The motor s…