-
Good Morning!
I have a problem that is not solvable for me.
If I want to disarm the quad, the ESC starts with a calibration. The video you can see here: https://www.instagram.com/p/BPFvpCdjhMD/
T…
-
Target is XracerSPI
Board is Xracer 3.1
RX = PWM 5
TX = PWM 6
Tried RC7, RC8 and Dev builds.
Softserial has no output on TX. Confirmed with a scope. Tested MSP and Smartport Telemetry. Both worki…
DaTwo updated
7 years ago
-
# INAV/SPRACINGF3 1.4.0 Nov 18 2016 / 15:34:15 (f0de3a8)
board: FuryF3 with MS5611
The problem: the sensor chart shows something like the derivative of the altitude.
I mean if I move the quad 1m …
-
I have experienced two crashes due to unresponsive flight controllers using the VTail mix. I've spoken to Dominic about as well, however in these instances when we have been flying acro. While doing f…
-
I'm using Naze32 rev 5 funfly with 1.13.0 stable firmware. Every time I hit the "save and reboot" button, it saves, reboots and then just stays like that. I click on another tab and it loads infinitel…
-
Hello
Given situation:
Flip32+ flashed with INAV 1.1 (last stable release).
Ublox M8N GPS connected at 19200Baud on softserial 2.
Serial RX (SBUS) connected at 19200Baud on UART1.
Telemetry connecte…
-
Powering the board causes an I2C error with the current version 1.3 and the baro is not activated in the hardware bar. After rebooting the board (switching to cli and back) the baro is detected and wo…
-
I observe that on first arm after powering up the motors start at high RPM which almost flips the quad if no RC control in immediately applied.
See this blackbox log - two motors start at >half throt…
-
I just updated my multirotor from inav 1.1 to 1.2. I am using the RMDO flight controller. I'm having trouble now controlling any servo via AUX channel.
Previously (inav 1.1), the servo worked (AUX 3…
-
Add support for V-tail airplane. Thus covering the entire range of airplane configurations that are used the most.