-
I am using a Arduino Pro mini 3.3V with a modtronix inAir9b device.
Pin mapping is as follows
.nss = 10,
.rxtx = 6,
.rst = 5,
.dio = {2,3,4}
I am able to send a join request and I can also …
-
Hi Mr Pham Cong Duc,
I used Arduino Pro Mini in its 3.3v, 8MHz which connected the HopeRF RFM 92W (Low-cost LoRa Iot Device: A step-by-step tutorial). But when i removed the power led and the board …
-
**Describe the bug**
BatchSD does not publish with Dendrometer code with both LTE and Ethernet usage. Dendrometer uses dirty integrated sensor values added to the json using the add_data() function. …
-
Hello,
(can you read my fift post?)
I actually have a problem and I have pain to debug or to find the start point to debug it.
I am collecting data sensor and I sent it each hour. It works fine. …
-
Is it possible to lower power consumption of RFM95? Data says in Sleep mode it consumes 0.2 uA and in Idle mode it consumes 1.5 uA. In my case it consumes 160 uA (ATMEL328P without RFM95 consumes 6 uA…
-
Hi,
Every time when i upload the sketch, The COM-port gets disconnected and I get a popup stating the USB-Device isn't functioning like it should.
I hooked it up according to your explanation, but s…
-
Using the demo code in examples/ttn-ota, I modified the setup() as shown below, and enabled debugging in src/lmic/config.h. If I comment out the LMIC_disableTracking() line, the code happily runs. How…
-
**Describe problem solved by the proposed feature**
This will avoid flooding the telemetry link with multiple requests due to longer communication times. We experienced the following when doing missio…
-
## Struggle with TinyGPSPlus and GPS TEL0094
Hello,
I am a beginner on Arduino. I am using a GPS TEL0094 pluged on a Adafruit Feather 32u4 RFM95 LoRa Radio. I have my GPS Module which works with t…
-
### Describe the problem
I have the following setup: https://github.com/arduino/arduino-ide/pull/1132#pullrequestreview-1031068976
When I start the application I see the following errors logged:…