-
### Application Version
5.2.2
### Platform
Windows 10
### Printer
FLSun V400
### Reproduction steps
1. Import a model
2. Watch it autoscale to some random value, usually way too small
…
-
### Application Version
4.13.1
### Platform
Linux (Manjaro 22.0.0)
### Printer
Flsun Q5
### Reproduction steps
The inner section of tree supports float in mid air and are not attached to anythi…
-
Enstop calibration starts, but I get a `Unknown command:"SET_PIN"`error after each re-home. Firmware reboots and console shows `Running Delta_calibration ` and then `Delta_calibration complete`, but d…
-
**Describe the bug**
Internal error during connect: cannot import name signature error message. If i comment out all autotune rows in the printer.cfg the printer can suddenly connect again
**To Re…
h3rm updated
5 months ago
-
### Is your feature request related to a problem?
Right now, when I go into the Material Manager, I have to create long Display Names to indicate which machine the material is set for.
This can be a…
-
### Application Version
5.2.2
### Platform
Linux
### Printer
Flsun Q5
### Reproduction steps
Open attached stl, slice.
4.x slices it correctly.
5.2.2 slices some weird shapes onto the top l…
-
### Version
_Version of SuperSlicer used goes here (help->about)_
### Operating system type + version
_What OS are you using, and state any version #s_
### Behavior
* _Describe the problem_
…
-
Good day. I have interesting problem.
When I turn on octolapse, the printer skips one layer. This happens mainly after the top layer of the model. When octolapse is turned off, the printer prints all…
-
### Cura Version
5.5 and 5.6
### Operating System
Windows 11
### Printer
Flsun V400
### Name abnormal settings
_No response_
### Describe model location
_No response_
### Describe your model…
-
### Version
PrusaSlicer-2.3.0+linux-x64-202101111322
_
### Operating system type + version
Linux 5.4.0-58-generic #64-Ubuntu SMP Wed Dec 9 08:16:25 UTC 2020 x86_64 x86_64 x86_64 GNU/Linux
on an…