-
Can the programmer also used with DxCore (AVR-DA and AVR-DB) and MegaCoreX (AtMega4809...)?
-
Since Latest commit, i get an error, No target power.
If i move 5V from the updi header, to 5V on the arduino ISP header, it works, and flashes the attiny412 (need 2 tries, as it should atm)
Usi…
-
Was reported in #225 that there may be a problem with the included bootloaders in 2.1.x - this is a serious issue for me, as I have shipped several boards pre-loaded with the new bootloaders and reset…
-
Hi
I have one of your programmers and I'm struggling to make it burn bootloaders. It fails & then refuses to communicate at all with the chip. I've tried it with 412s & 1614s & the failure is consist…
-
Can we get more options for Startup Time or a less aggressive minimum setting?
If using the ATtiny 0/1/2 parts as a HV programmer and the target has UPDI in GPIO mode, the HV pulse needs to be appl…
-
I have tried to flash the ATTINY404. But it did not work and always ended with an error message. I have then subsequently installed the capacitor and the resistor.
However, this also did not help to…
-
My thoughts were to use an external 32Khz clock and use the millis() function to do accurate time keeping for battery app. If i read the docs correct this could be a crystal with caps on the TX and …
-
If this works, will also allow UPDI to be fused as Reset and GPIO for non-optiboot definitions.
-
Hello,
I have spent some time trying to get high voltage programming working on the ATtiny3216 but have not been successful. I have been doing the same thing I do with the ATtiny412 and ATtiny1614 …
-
Note that the documentation for the Xplained evaluation boards has no information regarding high voltage tolerance of the programming pin. As shipped, all programming pins (UPDI or DBG) are **NOT** 12…