-
## Current Behavior
Upgrading my Nano Talon to iNav 7 and GPS stops working.
Upgraded my Nano Talon from 6.1.1 to 7.1.1 and restored DIFF and config as usual, no issues, but never actually checked…
-
### Device
Goggles V2
### Operating System (Including version)
windows
### Browser
Edge
### Trace ID (bottom left of the configurator screen)
v2.3.0 - Trace ID: 005904b1-64c3-4126…
-
## Current Behavior
in Some WP Mission constellations, the Jump-Command points at the wrong waypoint. Does not happen with every mission but seems to be related on the specific WP numbers or repeats.…
-
### Describe the bug
I tried mobile app with latest version [Betaflight Configurator 10.9.0-RC1](https://github.com/betaflight/betaflight-configurator/releases/tag/10.9.0-RC1)
I found this:
1) My…
-
Hi,
Following the new [feature of ELRS 3.0 which allows now to use Betaflight configurator connected to the FC wirelessly through ELRS RX AP or Home network](https://github.com/ExpressLRS/ExpressLR…
-
## Current Behavior
One of Motor mappings with the target FLYWOOF745 uses port E13.
## Steps to Reproduce
1. Flash the iNav version 7.
## Expected behavior
The motors shall be mapped as follo…
wsiok updated
2 months ago
-
Using
iNav 7.1.1
vtx firmware 1.6.0
Whoop vtx
The iNav "Video TX Power" OSD element always shows as 0 rather than 1 (25mW) or 2 (200mw)
This works fine in 1.5.0, but not in 1.6.0
I suspect…
-
## Current Behavior
Hello! During my last test flight with a fixed-wing aircraft using a gimbal and a head tracker, I experienced a total loss of control. The onboard recorded video is frightening.
…
-
Steps to reproduce:
1 run XPlane and connect to flight-controller (from plugin menu)
2 disconnect plugin (from plugin menu)
3 try to connect with inav-confaigurator - failed
But! If after the st…
-
## Current Behavior
No airspeed output in sensors. Unable to arm 'sensors calibrating'. Seems to work fine in 6.1.
## Expected behavior
airspeed to work and not prevent arming
## Suggested…