-
I am looking to use one of my older 4 pack boards to run a small 4 axis machine with the TMC5160 plug in drivers. I have an issue where everything works, but any update to the microsteps for the Z ax…
-
I recently purchased a queen bee pro with the
xpro v5 controller. I have installed the latest firmware, cncjs software and I'm at the point where I would configure my axis'.
I've opened The seria…
-
This issue will automatically convert a Grbl_Esp32 machine definition file to FluidNC YAML format.
Change YOUR NAME in the title to some string that identifies your machine configuration.
Attach…
-
I use Bigtreetech TMC5160 v1.2 driver in the full SPI mode (SPI_MODE - high, SD_MODE - low).
I set RMS current to 750mA however when there is a load on the stepper motor, driver sucks more current f…
-
I am running a 5161 on an ESP32, I am getting '0 1 292' and the motor is not moving, this is what i have wired
EN_PIN -> 14
MOSI ->MOSI
SCK -> SCK
CS -> SS (i have tryied Salve Select and a non-…
-
#### Description
Describe the issue or feature request in detail. Take a screenshot or record a video will be helpful.
#### Versions
- CNCjs: 1.9.x
- Node.js: 6.x
- NPM: 5.x
#### How Do …
-
Checking the documentation, there is none for version 1.2. The motion controller mode also appears selectable via solder pads on version 1.0, but there is no reference as to where those pads are on t…
-
I tried to compile this sample in order to test the UART mode connection. It turns out it fails to compile and shows a number of issues:
- `STEP_PORT` is not defined, I'd be nice to have a comment …
-
Don't use this version on the Ender 5 pro. the z-axis steps are 2x on ender 5 pro (it has a different z-axis screw) so this version of the firmware will only move up 1/2 the correct amount, which of …
-
Please provide the documentation for v1.2.