-
The Wireless driving works decently well with the Pi, however, there is some latency due to using a router within the network. We can fix this by using a P2P network Antenna such as [this](https://sto…
-
I am trying to have a mesh network which one of them is Gateway and it need to be connect to WIFI and internet to transfer data by MQTT. I am using PainlessMesh to create the mesh.
Issue I have When …
-
How do u connect the ESP8266 in linux as serial connection over wlan without usb or something ?
-
Good day. I received the T-Halow units today, but I have a few questions after looking over your site.
When I plug in via USBC on a Linux PC I can see the ttyACM0 and go there to see stats about t…
-
I am using the tuanpmt code & libraries to run an Arduino multi sensor to send mqtt messages through a ESP8266 (Bridge Mode)
The code below runs ok, but the trouble is that it only publishes the mess…
-
Hi!
I'm using ESP-Link as a serial bridge for an Arduino Adalight project.
Using serial to tcp software and ESP-Link I get over 250ms of lag compared to straight serial connection.
Using Windows 1…
-
Hi im tryng to get work AppleMIDI example.
i have an error
```
Arduino:1.8.12 (Windows 10), Scheda:"DOIT ESP32 DEVKIT V1, 80MHz, 921600, None"
In file included from C:\Users\Damiano\Document…
-
Hello,
I would like to spy or monitor communications on an eBUS system. I was wondering if ebusd-esp can be used for that? It would be useful to see what messages the control panel sends on the bus…
-
The Primo has an ESP8266 on-board which works with StandardFirmataWiFi on it's own, but it's connected to the nRF52832 via UART so I'm not sure how that could be translated into how StandardFirmataWiF…
-
Hello. I notice there is no guide for SSC333 however there are references to it in the source code. Does this mean that it could still work (unofficially) if I build the firmware myself? Is there any …