-
Hello,
I am trying to test the yolox people detection on gvsoc.
I am using the gap_sdk_private with the 5.7.1 version and the last yolox people detection repository.
I have launched the following…
-
I have purchased esp32-s3-korvo-2 v3.1 development board and followed the getting started guide , but unable to run the sample code , it reporting a --- A stack overflow in task ipc0 has been detected…
-
Is there support for RTL8710CM yet?
I have a couple of devices (Tapo L920 LED controllers) using this chip and would love to be able to flash them with libretuya/esphome.
-
Magisk (4f18a66d) (27008) (D)
Xiaomi RN8t (willow)
crDroid 10.8 (Android 14)
The installation is successful, after rebooting the recovery just opens.
Version 27007 works fine.
![Screenshot_2024…
-
I configured my device on the pre-installed FW. Everything was working fine. Then I updated to the latest version. The update completed successfully and then after several hours the device disconnecte…
-
**Describe the bug**
I have a Quectel EM05-G today a new firmware release is out, but when I want to update my device it fails and give me this error :
"Message recipient disconnected from message b…
-
Hello,
Despite all my attempts, reading of [PluginFlag:esp not found](https://github.com/fwupd/fwupd/wiki/PluginFlag:esp-not-found) and some other links, I still having the `WARNING: UEFI ESP par…
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
Hi guys,
Have new BBB where i want to claim all P8[0] bank as inputs and P8[1] as outputs (outputs not done yet).
Disabled all overlays + universal one too. However I am getting bunch of conflicts…
-
Hello,
I have an issue since few month, build of arm64 freeze on ``Preconfiguring packages ...``. I test more than 24h and nothing more.
```
Sending build context to Docker daemon 810.5kB
Ste…