-
The small line that is supposed to be the pin 1 indicator is too close to pad 1. Once soldermask clearance is taken into account, the silkscreen line would end up falling on bare FR4. This happens wit…
-
- [x] Document problem → see below
- [x] Brainstorm if this problem can be solved → yes, see below
- [x] determine joint mounting hole Ø → 8.5 mm
- [x] Check polarity: HDPLEX states in data sheet that…
-
Power Modules, DIY Modules and all of the new ATmega powered modules are very fragile and easily broken if too much force and pressure is applied to the top PCB (mostly the side of the module with no …
-
Hey guys,
Just found your work, awesome stuff. You mentioned you found somebody on alibaba. Can I have a link to the supplier?
-
Nominally we suggest PWR pins are located at the top of a symbol, and GND pins at the bottom. However this is not stated in the [KLC rules](https://github.com/KiCad/kicad-library/wiki/Kicad-Library-Co…
-
Hi,
i'm doing some quick and dirty test on the IMU algorithm, in terms of raw computational power.
As test bed i'm using an AfroFlight, so no FPU on board and very diffuse model.
I probably have a b…
-
- [x] HC: Write Proposal of [Production Plan Golden Sample v1](#issuecomment-216448677)
- [x] HC: Discuss in Team. If big changes document them in v2
- [x] HC: Write Proposal of [Production Plan Golde…
-
Just in case someone else has this problem: on my right hand board (Infinity Ergodox), the via from the anode of D66 to D56/D51 appears to have been misaligned (or the trace failed somewhere along the…
-
I'm not sure if it's connected with recent GPS glitches from #431 or #346 or windy day, or new baro or whatever since SD card was loose in logger and I do not have a log from that mission.
Build base…
-
Running the attached gerber through the latest version of gerber-to-svg, I get the following svg header:
``
(only the relevant bits)
The width/height attributes are correct, however the coordinates a…