-
Running this board in UART mode with TMC2209 drivers. Tried every port after 1, 2, 3 and I can't get the extruder to work for the life of me. I can get it working by plugging it into a 1, 2, 3 config,…
-
0x6F for DRV_STATUS in datasheet shows 3 flags missing from the inherited TMC2130 struct. For TMC5160 should have the following that includes s2vsa, s2vsb, stealth instead of the reserved 5 bits.
…
-
Thank you for your efforts. I installed Repetier yesterday, and it was a breeze to setup on my machine - a Sharebot ng.
The print quality comes out better than Marlin's, i.e. The outer/inner perime…
-
Hi,
When i operate my machine,both the axis are moving together with a single axis command.
the machine move diagonally with any X or Y axis command.
can you help me to fix it?
-
### Controller Board
Custom controller, based on 6-Pack schematic, external stepper drivers on I2SO pins, no SD card slot
### Machine Description
DIY machine
### Input Circuits
_No resp…
-
As the TMC Stepper driver from https://github.com/bigtreetech/TMCStepper are outdated it is not possible to use the current Marlin version.
### Current behavior
When building with in `platform.ini…
-
Hi Folks,
Can anybody tell me does firmware stepper voltage control work for the Robin Mini with Marlin 2.x? I am in the process of converting over and want to know what to expect here.
-
Is there need change Swift pro's code?
-
As we are checking our electronics of cnc machine, I will explain what I did or doing till now
I connected arduino uno with computer and load hex file successfully in it by x loader then i will done …
-
Just wondering if anybody else experiencing this. Set my controller to 8tpi on slowest spindle speed, turned spindle speed to maximum servo matched speed. When I turned speed back down servo kept r…