-
I think there is potential for the thermocouple connector milled slots to cut too much into the footprint of connector and break the connection. It really depends on how everything is soldered togethe…
-
The buzzer buzzes while flashing device. Should this be a feature or a bug? Let's call it a bug. Could be a hardware change or a firmware change.
-
Fix: Add the new scope logo.
-
This will limit any memory usage. I believe we are already in this state.
Ref, "Between the u8glib, vprintf, sd and usb there is not much left of the 32K flash. Having an open source project with low…
-
Add a jumper inline with the battery to measure the current. This should normally be shorted with a trace that can be cut. The jumper can then be bridged with a solder blob.
-
We need a good solution for the thermocouple connector.
I've been using these for prototyping. I like that they have good thermal contact with the board. The major issue with this is that it deforms.…
-
In my original prototype I used M2 screws, which has carried over to the production design. I think it might be good to make explicit decision about this. @starno do you think the M2 screws be strong …
-
Use an independent microcontroller to handle the SD card operations. The goal is to support the FAT32 filesystem while working within the limitations of the 32u4.
-
The test hook hole should be large enough to fit a test look like the ones below. Will the hold fit
![screen shot 2014-12-12 at 10 49 16](https://cloud.githubusercontent.com/assets/281642/5406359/1e73…
-
The SD card should be at the enclosure edge when it is inserted. We will probably need a new connector.