-
I'm trying to copy with VS Code, which always works until now and suddenly impossible to compile, I always get the error that "libmaple / gpio.h" cannot be found ...
![Presse-papier01](https://user…
BelSD updated
4 years ago
-
:( tried a bunch of alternatives and nope still...
-
In the common.graph branch (the precursor to JUNG 3.0) there are now some types for supporting tree structures: https://github.com/jrtom/jung/tree/common.graph/jung-api/src/main/java/edu/uci/ics/jung/…
jrtom updated
6 years ago
-
CB1 didnt support a dsi camera/display?
Only HDMI?
Why?
-
I have a new Octopus 1.1 board with F446 Chip. It had firmware already loaded which i could control via octoprint but wasnt for my boards. No matter what i did it would not accept any firmware from an…
ghost updated
2 years ago
-
Hi, Thanks for sharing this bootloader + firmware. I have an SKR-2 which should use the same bootloader. Where did you get the source for the bootloader? Would you mind adding it to this repo?
Than…
-
### Is your feature request related to a problem? Please describe
I using BTT relay as safty measure, for that I need to setup PE4 pin to true during boot to avoid the relay cut the power in the mean…
-
Running this board in UART mode with TMC2209 drivers. Tried every port after 1, 2, 3 and I can't get the extruder to work for the life of me. I can get it working by plugging it into a 1, 2, 3 config,…
-
hi.
i using skr2 + tmc2209 in my 3d printer
recently, my tmc2209 driver was damaged after printing over 24h, 35°C (stepper is nema 17HS3401, 24V)
then, i found that reason is short between G…
-
Been having issues getting the CB1 to work with the Bigtreetech Pi4B adapter and I cant get the camera to work. I get nothing out of the HDMI port.
I've tried to run other versions of Pi and nothin…