-
The EKF2 (and probably EKF3) do not try to handle a change in the primary GPS which is almost guaranteed to cause a change in position. From what I can see, the EKFs simply handle the sudden change i…
-
Hello,
I seem to encounter strange behavior while trying to use my M8N receiver with 2.01 firmware version with RTKLIB 2.4.2 release. I am on Windows.
[NOTE] I have just tried the 2.4.3 b33 and I ha…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
Using an OEM H7 you can't get a GPS to work, using the GPS port or CAN, neither show up with `gps status`
```
NuttShell (NSH) NuttX-10.1.0
nsh> gps status
INFO [gps] Main GPS
INFO [gps] protocol: UB…
-
Hallo, ich habe in der Configuration gesehen dass NEO-6M unterstützt wird und am Pin D5 und D6 unterstüzt werden. Zustätzlich habe ich ein Display SH1106, SDS001, DHT22 und eben den GPS Sensor NEO-6M …
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…