-
There is some serious jitter due to bad task scheduling. Some periodic parts of code can cause huge looptime variations. A good example of those is rx code and baro. Control loop should be as jitter f…
-
I have a problem with the Naze32 10DOF, and GPS. I have 2 Neo-6M modules, that connect well to the u-centre, and get many sats, low HDOP, and a fast fix even indoors, but, when connecting to the naze,…
-
Is there any reason why FC_VOLTAGE_CONFIG is not usable with BETAFLIGHT? Only for CLEANFLIGHT and BASEFLIGHT (see: [Def.h](https://github.com/ShikOfTheRa/scarab-osd/blob/6f3156f4083d17595e35bf4555df8d…
-
Hi. I install Ublox 7 on CJMCU but cant worked when I set GPS to Ublox after save and reboot its jumped to NMEA !!! the firmware is version 1.9.0. (the port GPS is enabled and baud set to 57600)
pl…
-
https://github.com/cleanflight/cleanflight/pull/2075 and https://github.com/cleanflight/cleanflight/pull/2090, it is easy to implement 4way interface over MSP.
With it, it would be possible to confi…
-
What if fcu_io had a service that rebooted us into the bootloader. I think that there are some ways that cleanflight reboots itself into the bootloader. It would be handy for development.
-
i have problem with sonar too. even though i turned sonar feature on its not turning into green. Oneshot125 esc is also not working. everything was fine before upgrading. Can anyone give me solution?
-
I'm running a lemon rx satellite receiver and a spektrum DX6 as well as an SPF3. I was able to bind the DX6 to the satellite using the cleanflight CLI however none of my stick inputs show up under the…
-
I tried to change the cmix values for my tricopter in the CLI to compensate for non-standard COG position.
When doing:
mixer tri
cmix 1 1 0 1.586 0
cmix 2 1 -1.352 -0.414 0
cmix 3 1 1.352 -0.414 0
sa…
-
Original Issue over at cleanflight : https://github.com/cleanflight/cleanflight/issues/1398
Original pullrequest over at cleanflight: https://github.com/cleanflight/cleanflight/pull/1604
Short d…