-
### Category
Other
### Hardware
Not Applicable
### Firmware Version
2.3.12
### Description
UBlox M10x GPS module stays in aquisition mode (~12mA) and does not enter sleep mode (~50uA) if meshta…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
Some transmitters set the internal time when a GPS-Time-protocol is received from a sensor.
Is this something that can be added to the protocol?
Best regards
Onki
-
I was just testing my build today hovering with angle mode and disabled and enabled it a couple of times and after that I checked blackbox logs and it shows that every time when I did that, VTXPITMODE…
-
Hello,
I did some "time" testing.
The test consists of compare the PPS (pulse per second) generate by a receiver with real Sats signal vs a PPS generated by a receiver with signal generated by g…
-
```
This will make the arduino set the GPS receiver to 57600baud 10Hz every time
the arduino starts:
////////////////////////////////////////////////////////////////////////////////
////////////////…
-
GPS Ublox NEO серии M8.
Интерфейсы UART и SPI.
Коммуникация с MCU по SPI.
Из доки
* maximum SPI clock speed of 5.5 MHz
* only the UBX/NMEA message stream is provided
* If the receiver has no m…
-
The EKF2 (and probably EKF3) do not try to handle a change in the primary GPS which is almost guaranteed to cause a change in position. From what I can see, the EKFs simply handle the sudden change i…