-
So ive upgraded to the BTT E3 v1.1 board.
Installee latest reprap firmware, set up the wdc interface and got everything up and running.
everything works just fine except for homing, my x and y axi…
-
The onboard system bootloader (BOOT0 set high, BOOT1 set low) present on the STM3240xxx series only waits 780 microseconds for the crystal to start. The SKR Pro 1.1 comes with 22 pF capacitors that ov…
-
Hello,
I am working with a TFT35 V3 E3 that is connected to an SKR2 Rev B; all on a Creality Ender 3 Max. I have had this collection working in the past, but have recently redone the firmware to a…
-
Hello,
after a long try and error i have got my Ender 3v2 to work with the skr mini e3 v3 but the printer behaves strange. I wanted to print the calibration cube. When i start the print, the printer …
-
### Is your feature request related to a problem? Please describe.
I installed a BTT SKR Pro v1.2 into my Ender 5 Plus and was having a difficult time figuring out how to configure the X and Y end-st…
-
### Describe the feature or hardware support you'd like
With multiple Brands coming out with a repackaged PandaPi BD Sensor(BTT is the latest one with the EDDY sensor) it would would probably be good…
-
All SKR boards I used failed on USB connection after using sometime. This issue present in all SKR models including SKR1.4 / PRO SKR3/PRO/EZ. No apparent cause found. No any connection whatsoever to r…
-
so I just wired up the skr mini e3 2.0 and flashed the firmware-bltouch.bin from the github page. The Bl-touch is plugged into the five pin dedicated port on the SKR. Everything functions as it shou…
-
Hi. Hope someone can help me. The board works fine, which mens i can upload new firmware and i can control fans and other hardware devices using PrintRun for Mac. But when i try to control the stepper…
-
I've been trying for 2 days to recompile other folks firmware and also tried editing the stock marlin 2 software to no avail. I am using VSC and Platformio and I have no experience with this kind of s…