-
I believe think it might be possible to break the chip by mistakenly setting la0 (`active`) to `0xFFFFFFFF`, thus activating all the designs at once.
Can we protect against this?
urish updated
2 years ago
-
Similar to the thrusters, the current available from the pins on the Xavier is too low and thus turning the magnet off using the GPIO pins is not working as expected. We will need to pick a new resist…
-
I struggled quite a lot to build this because i followed the instructions very precisely, and when they were not clear i followed the pictures. When these were unclear i searched online.
- At first…
-
Hi Botox
I'm unsure about wiring, because of the following warning:
> Do not cut the big - trace on the M365 ESC or it will damage the BMS because of different GND potentials on UART!
**I hav…
-
I have wired my grbl 0.9j with the inverted Z limit and variable spindle option.
But i have to drive a SSR with the D11 to control the spindle, how to output at his pin a clean 5V to turn on the rela…
onekk updated
9 years ago
-
I'm trying to use g2core on an Arduino Due with level converters and externals TB6560 drivers which require active low step signals. How can that be accomplished?
Thank you!
-
Hi Sebastian,
I‘ve found this project via [your blog](https://blog.sebasgo.net/2019/02/28/sunrise-alarm-clock-pi-dawn/) and am really interested in conducting a similar project myself.
Unfortuna…
-
This is not really an issue but an improvement I've been thinking about, We can discuss here.
Parsing the C header files is somewhat ambiguous and artificial logic is in place to try to be tolerant …
-
Hello,
i recently bought a used Hoverboard .
The Split PCBs look almost like the GD32F130/v17=2.19 Gotrax, but not quite.
some Photos attached.
i try to use the Gotrax config and report my p…
-
### Description
In Marlin 1.1.8 and the most recent bugfix (with a completely virgin install), disconnecting the thermistor leads does not trigger a Mintemp or Maxtemp error. This is obviously a …