-
Hi, could you please assist with the following issue or provide hints what to try next?
### Problem
Cannot extend SDR range with [official instructions from AD]( https://wiki.analog.com/university…
-
We need to flash the esp32 from the jetson over the uart connection we use to communicate with power loop.
-
## Environment
- Audio development kit: ESP32-LyraT-Mini-1.2
- [Required] Module or chip used: ESP32-WROVER-E
- [Required] IDF version v5.2.2
- [Required] ADF version v2.6-159-gdac74d81
- …
-
The CH347 supports hardware SPI for faster speed
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have up…
-
I cannot figure out which pins to set for the reset script.
spi and i2c are enabled.
tyro@rpiz:~/LR1302_loraWAN/LR1302_HAL/sx1302_hal/packet_forwarder $ ./reset_lgw.sh start
CoreCell reset thro…
-
Hi
I followed the instructions https://github.com/SvenKiljan/archlinuxarm-pbp/blob/main/INSTALL.md#installation-on-microsd-card-or-emmc-module to install Arch Linux Arm on an SD card. Everything we…
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
Hi,
I have been trying to install titan extruder, which needs recompiling firmware.
I followed exact instruction on readme, and got compile error.
Below is the error messages I got.
Tried both S…
-
When the Digilent Atlys is still running the firmware which ships with the board (supplied by Digilent) the SPI flash is automatically configured in QSPI mode which openocd doesn't know how to talk.
…