-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
### The problem
When i try to fetch the groups using this command `curl -X GET -H "Content-Type: application/json" 'http://OBFUSCATED/v1/groups/+OBFUSCATED'` i only get the error message: `{"error"…
-
Running the test `eth_fw_data_check` causes luwen to think that DMA keeps going so the chip hangs with the following error -
`It is not currently safe to communicate with ARC because, there is an o…
-
Two device tree overlays cannot specify chip-select pins on a single SPI device.
For example, if a board revision introduces a device on an SPI bus, and then a shield also introduces a device on th…
-
Hello,
SPI.begin is inside the comment here:
https://github.com/JQIamo/AD536x-arduino/blob/973da6937a741e8c4176e5d58689b1e054edfa08/AD536x.cpp#L71
It should be outside, otherwise SPI communic…
-
When testing dagger with ~K2~ Kapt on Kotlin 2.1.0-Beta1, it fails with the below trace.
### Repro
- Checkout https://github.com/slackhq/circuit/pull/1677
- Set `kapt.use.k2=true` in `gradle.prop…
-
I use the library with an Arduino Uno. `Simple.ino` works exactly as expected. I use this pin setup:
```
#define EN_PIN 7 // Nano v3: 16 Mega: 38 //enable (CFG6)
#define DIR_PIN 6 // 19 …
-
See StratifyLabs/StratifyOS#157
-
Hi,
i have problem with my ArduCAM. I connect with RaspberryPi and level voltage in SPI is higher than 3 V. When camera is connect with RaspberryPi in SPI pin is 3V3 but when I started program this l…
-
## CVE-2024-27028 - Medium Severity Vulnerability
Vulnerable Library - linuxlinux-4.19.313
The Linux Kernel
Library home page: https://mirrors.edge.kernel.org/pub/linux/kernel/v4.x/?wsslib=linux
F…