-
It'd be really helpful to people getting started with Rust and the RPi Nano to list what hardware probe model was used in testing this project and how to connect it.
I've successfully used SWD thro…
-
The NXP MCUXpresso SDK v2.15 updated the Flash Control Block (FCB) used for the MIMXRT1170-EVK board . These changes to the flash boot settings have broken pyOCD support for this board now. If an ap…
-
Hello world :-)
Something terrible happened on my system and pyOCD started to segfault :-( I have tried different pyOCD versions, Python versions, etc. Was there a big change in USB handling recent…
-
I'm getting the error 'No cores were discovered'. This happens after successfully flashing a valid program.
If I erase the chip (using MCUXpresso, the official IDE for LPC845), the pyocd is able to d…
-
# Server
- OpenOCD should be 0.9.0, not 0.10.0
```
$
openocd -f cc3220_xds110.cfg
Open On-Chip Debugger 0.9.0 (2016-09-30-17:45)
Licensed under GNU GPL v2
For bug reports, read
http:/…
-
I can't use ESPhome HomeAssistant add-in, while my RPi 3b, does not have enough memory.
I want to setup a Bluetooth-proxy. I can with the ready made package through https://esphome.io/projects/?type=…
-
### Describe the problem
It is required to configure the udev code in Linux to provide access to the Serial port. Otherwise, it is not possible to upload sketches to the Arduino board.
Given that …
-
> Probe: LPC-LINK2 CMSIS-DAP
> PyOCD Version: 0.22.0
> Target: LPC55s69
When start gdb-server, pyocd reported error. I killed process and start again, it would be OK.
I can reproduce the problem…
-
I've seen this before, but didn't record cases, and now I do. https://staging.validation.linaro.org/scheduler/job/282676 shows that a test may get output from the previous binary flashed on the board …
-
I expected CDC's PORT to show up.