-
Using V 1.2.14, I've got one trace running, any output, SWR, LogMag, smith...etc - giving a good trace of an antenna.
Every few scans it pauses..... though the menu's still respond. I've not click…
-
Hi Hugen,
here I publish my mods to almost completely fix the loss of dynamic above 300MHz when the DUT is a LPF tuned below but closed to 300MHz such as VHF/UHF duplexers.
The mods on my prototype …
-
Hello,
I'm just asking whether it would be possible to add to the NanoVNA menu the "absolute impedance" /Z/ as well, rather than only resistance (real and imag) separately.
Real and Imag part is im…
-
Loading any saved Calibration File ends up in an:
what(): matrix rank is not full! should be 4, is 3
Exception
(Current Appimage running on Debian)
-
I figure there is already a good chance you have considered adding an on device capture function but dismissed the idea due to memory limitations. (I know pgm is very very tight). Now what if instead …
-
I tried version 1.2.14 after 1.1.01 and found that 2 of 5 times the device won't boot at all, sticking on a black screen.
After turning it off and on again, it booted and worked well. Clearing config…
-
1. Stratux version:
2. Stratux config:
SDR
- [ ] single
- [x] dual
GPS
- [ ] yes
- [ ] no
type:
AHRS
- [x] yes
- [ ] no
po…
-
What output Impedance could I expect from Raspberry when I am transmitting with FM on VHF frequency 145Mhz (Ohm)?
-
Hi Martin,
here the integration with W600-Module (not use of Air602 because of lacking antenna !) .
[https://wiki.seeedstudio.com/W600_Module/#firmware-programming](url)
[https://files.seeedstudio.…
-
I am using NanoVVNA-H4 v4.3 and firmware v1.2.30.
I expected that raw (ie uncorrected) s21 phase would be close to 0°.
![nanovnah4_20240608_132439i](https://github.com/DiSlord/NanoVNA-D/assets/429…