-
#### Issue details
Failsafe events cause airplane to enter RTL when not flying. This is dangerous. A typical scenario is an the RC transmitter is held too close to the receiver and signal is lost, or…
-
### Description
The first row of Vertical list(RTL FlowDirection) isn't correctly aligned from right-to-left.
### Steps to Reproduce
1.Deploy https://devdiv.visualstudio.com/Pkgs/_git/VS.Test…
-
So, after my commit
```
sudo modprobe rtl8723ae
```
Is working, and driver is loading.
But my card can't find any wifi networks.
lsmod | grep rtl
```
rtl8723ae 86360 0
rtlwifi …
-
root@stratux:/# sudo stratux-zero/setup.sh
All good from here to:
The following package was automatically installed and is no longer required:
libfuse2
Use 'sudo apt autoremove' to remove it.
0…
-
### Analysis
I am running a vanilla OpenMQTTGateway on a LilyGo RTL 433 Module. Sometime the firmware crashes with the information shown below. I can reproduce the exception when I power on an Orego…
-
I had some issues with my RPI running goestools and goes-vitality recently. power supply died and memory card was corrupt. After replacing both and rebuilding the pi using the latest 32bit build I am …
-
I have one of those tygwzw1 that arrived kinda broken - WiFi part was working but was unable to communicate with ZigBee module.
Not sure about the reason (RTL side shows constant retry with different…
kitor updated
3 months ago
-
The communication tether is a system that is based on RF communication
# System Constraints:
## ROV (Prototype):
The system must allow commands to be sent from shore to the ROV underwater
**Constrain…
-
Hi,
Firstly, thanks for the fantastic rtl_433 tooling. Amazing work!
I'm trying to add support for a kinetic-powered switch, which is typically 'paired' via RF to one or more receivers such as S…
-
I ran an `rpi-update` a few days ago to test if it solved some SPI CS issues, and since then the Bluetooth stack on my Raspbian on RPi4 has been broken (although I can't completely rule out if it was …