-
Hello !
I read the pinout from utilities.h and I write a micropython code to mount the SD card :
```
from machine import SPI, Pin
from sdcard import SDCard
import os
import hw
power_en = …
-
I have added a 8 bit wishbone peripheral as follows:
```
class SpiModule(Module):
def __init__(self, platform, spi_miso, spi_mosi, spi_ss_n, spi_sclk):
self.bus = bus = wishbone.…
-
Are there any plans to add SPI support for communicating with your short-range devices (e.g. NINA-W156)? Maybe there is another library that uBlox has to already support this?
Thanks :)
-
How do I make the spi_uart to work with a periphal? is it intended to replace spi.h?
-
Hi Pierre,
I was successful in using acan2517 lib on Arduino nano with MCP2518FDClick board as sender and UNO with MCP2515 as receiver. I am unable to do the same with pico development board, The p…
-
The following SPI pins are swapped
```
SPI0 MISO| |GPIO 10|19|
SPI0 MOSI| |GPIO 9 |21|
```
should be
```
SPI0 MOSI| |GPIO 10|19|
SPI0 MISO| |GPIO 9 …
-
Good afternoon. So I was able to compile the firmware and run it on my flight controller with AT32F435.
But two problems have emerged.
1. It has not yet been possible to launch the SD card via the S…
-
I was trying to work around this issue https://github.com/Lora-net/LoRaMac-node/issues/1594 by calling `Radio.Sleep()` after LoRaMAC init with NVM restore. My initial issue is this one https://github.…
-
The only definitions in "spi_host_structs.h" are currently:
`#define spi_host_peri ((volatile spi_host *) SPI_HOST_START_ADDRESS)`
It should be changed to something like (since all three periphe…
-