-
### Describe the bug
after flashing bf 4.4.0 rc3 when on configuration page gyro is not detected.
### To Reproduce
flash bf to crazybeef4fr with BMI270 gyro, apply custom defaults, connect, go to c…
-
### Describe the bug
After flashing 4.4RC5, launch control is missing from the CLI.
# get launch
###ERROR IN get: INVALID NAME: launch###
### To Reproduce
Flash 4.4RC5, go to CLI, type "get lau…
-
## 🐛 Describe the bug
See for example https://lift.sonatype.com/results/github.com/NASA-PDS/registry-api/01G0G09HRN3M99XVM8V7BS0KGK
-
I use the version 1.1.0 but my gps isn't discovered.
Version = 1.1.0
Function Pin Change entering XXX=yyy (yyy=255 to disable)
Primary channels input = 5 (PRI = 5, …
-
There are ODATA APIs protected with CRSF. For that you need to assure that the relevant CRSF data returned on the first call of a user session are used in subsequent calls as well
Details:
On the …
-
Hi,
Ethos 1.4.1 / Tandem X18S
I am missing values for telemetry sensors with ELRS. I use ArduPlane 4.3.0 with an ELRS Rx which provides the data via CRSF. I use the same backend for a comparison…
-
Hello Mstrens,
I just installed the new test version 2.2.2 to check the DIY5104 sensor.
System FrSky X20S with FBUS protocol.
I think it's either the query speed (too slow) or I've activated too ma…
-
I am back to zero.
Put 0.3.4 on one of my RP2040. Now blinking red
I only have PRI on 9, TLM on 10 and SEC on 13.
No GPS, no baro, no voltages.
Start the radio and the power up the RP2040.…
-
### Describe the bug
Affected board: iFlight SucceX-D Mini F7 (IFLIGHT_F722_TWING)
Over the last weeks I flashed from RC1 to RC4 for bf 4.4.0 and since flashing RC4 I had to press the bootloader b…
-
I found from source code that 1/3, 32/33, 17/16 pins used for serial and I tried all. But I can't get ELRS working.
I guess 1/3 is not possible to use. (UART1 in BF terminology)
Is 17/16 (UART3 i…