-
as per subject would it make sense to update Ramps FD ? are there any improvements that could be made?
-
I am running into an issue where the BlueGigaEmpeg module does not boot and pair properly in a cold "first thing in the morning in the winter" situation.
The behavior mimics the issues I was having…
-
Yesterday the I2S audio developed an occasional intermittent crackle sound. Like a digital version of dust on an LP record. This is after weeks of perfect operation.
The crackles are each a single …
-
Hello.
Please add our new Arduino library for the Pololu Dual G2 High Power Motor Driver Shields to the library manager:
https://github.com/pololu/dual-g2-high-power-motor-shield
Thanks!
-
Hi, I was using your code and I tried to run `python stepwavetest.py` when it gave me the error
> File "stepwavetest.py", line 246
yield self.steppinmask, 0, 0
SyntaxError: 'return' …
-
It's possible that if you disconnect the 5V supply to the Betz board you might be able to power 3v into its 3v3 pin.
Check to make sure that your 3v output pin from the Arduino is really generating…
-
OK guys,
a while ago, i created a 8in1 PCB for the Chorus Tracker. It was my first design and of course the PCB was not 100% correct. There were some GND Pins of the Arduino not connected together …
ps915 updated
6 years ago
-
Another guy where the Z axis isn't working. GRBL 1.1 with Protoneer CNC shield. All end stops functioning normally; if I drive the Z axis against the stop by jogging, it throws a proper error. Duri…
-
Hello, complete noob, needs advise on his setup.
single motor, 57BYGH420-2 ( nema23, 2a per coil,
https://french.alibaba.com/product-detail/stepper-motor-57bygh420-2-125-oz-in-200-steps-rev-600mm…
-
After upgrading to new hrtool following issues are present:
- motor_safety cant start with error: "This package should not be accessible on python3" on import rospy
- pololu_motors: "No mudule named…