-
I'm new to the embedded-hal ecosystem, so apologies if this is a dumb question. It may also have more to do with the PL022 hardware than this crate.
I'm trying to configure a TMC2130 stepper driver…
-
### Current Situation
Hello,
I bought by accident an UART board with the SX1278 (see link below).
Do you plan to add a UART mode to your code?
https://de.aliexpress.com/item/32791728376.html?a…
-
Someone from this thread ( https://forums.whirlpool.net.au/thread/9jwqvxm3 ) dumped the SPI flash of a CM8200B cable modem. I compiled ProgramStore and ran it, but the SPI flash doesnt appear to follo…
-
Hello,
SPI.begin is inside the comment here:
https://github.com/JQIamo/AD536x-arduino/blob/973da6937a741e8c4176e5d58689b1e054edfa08/AD536x.cpp#L71
It should be outside, otherwise SPI communic…
-
I use the library with an Arduino Uno. `Simple.ino` works exactly as expected. I use this pin setup:
```
#define EN_PIN 7 // Nano v3: 16 Mega: 38 //enable (CFG6)
#define DIR_PIN 6 // 19 …
-
Has anyone tried the hard I2C and SPI modules in the UltraPlus FPGAs and got them working? I have spent the past few days tinkering away using the information in these documents:
http://www.lattice…
-
Hi,
i have problem with my ArduCAM. I connect with RaspberryPi and level voltage in SPI is higher than 3 V. When camera is connect with RaspberryPi in SPI pin is 3V3 but when I started program this l…
-
See StratifyLabs/StratifyOS#157
-
Hello,
I integrate the SPI management words:
```
#define ENABLE_SPI_SUPPORT
//.......
OPTIONAL_SPI_SUPPORT \
//......
// *** Support SPI ***
#ifndef ENABLE_SPI_SUPPORT
# define OPTIONAL_SPI…
-
right now it can only do writes. we'll definitely need this if we do mnemosboot...
hawkw updated
11 months ago