-
Hi @digant73 first of all thanks for your firmware releases! :)
I am having an issue when editing my mesh bed level.
So lets say I have a mesh bed level point adjusted to 0.13mm already, but I wan…
-
Hello,
"Bigtretech skr mini e3 v3.0 32 bit”
BLTOUCH is already installed.
I am using the "Ender Extender 400XL (for Ender 3 PRO)" kit.
The print area is therefore oversized 400mm x 400mm.
C…
-
### Description
So... I have a BigTreeTech/BIQU SKR v1.1, and am able to use TMC2208's in single-wire UART mode, thanks to work associated with https://github.com/MarlinFirmware/Marlin/issues/1319…
-
Is anyone experiencing random restarts after printer has been printing for over an hour?
Having finally got my BX printing well, any model that requires long print times fail. I've printed the usua…
-
Hi everyone, I bought two tmc5160 from bigtreetech more specifically these https://www.biqu.equipment/products/bigtreetech-tmc5160-v1-0-driver-spi-mode-silent-high-precision-stepstick-stepper-motor-dr…
ghost updated
3 years ago
-
HI, bootloader has been erased. i cant flash with sd card, and cant connect over USB.
Can you share bootloader.bin with guide for flashing to recover my board?
-
How do I install CANHAT from waveshare on `CB1`. I believe it needs
```
dtparam=spi=on
dtoverlay=mcp2515-can0,oscillator=12000000,interrupt=25,spimaxfrequency=1000000
```
but not sure how to g…
-
Hi, I have been very unsuccessful on adding either an ESP8266 S-12 or a 3dMellow ESP32 module to my SKR2.0 vB boards. What is needed to prepare the wifi modules for use? If I just plug them into th…
-
Hello, i'm using PI4B + CB1.
I installed KIAUH , Klipper and Moonraker without problem, wifi work perfectly, but i can't connect to the printer the CB1 can't see the MCU wich was previously flashed …
-
Hello,
My computer (under windows 10) didn't recognize the Tango V1.0 when i connect it via usb. In the device manager it tells "unkown usb device (device descriptor request failed)". I didn't find…